1. Place the box on a stable, ventilated work surface and check the supplied instructions.
2. Check that your material is UV-curable and compatible with the device. Follow the resin maker's layer-depth guidance.
3. Arrange pieces on the tray without stacking them. Close the door before starting a cycle.
4. Begin with the resin maker's recommended settings, let pieces cool, and inspect all sides before handling.

Disconnect the power and let the device cool before cleaning or storing. Keep liquids away from electrical parts and follow the supplied manual for cleaning. Check the cable and moving parts before use.

Match the lamp to your resin or emulsion requirements. Do not assume ordinary two-part epoxy is UV-curable. Avoid direct eye and skin exposure to UV light, and use the protection and ventilation required by your materials.

Setup and care overview. Need the complete instructions? Send us your model and order details.

1. Charge the lamp using the power specification in the supplied instructions.
2. Unfold it on a level surface and set the height and panel angle for your mold.
3. Select a timer and cure a small test piece using your resin maker's instructions.
4. Inspect and cure accessible surfaces as needed, then switch off and let the lamp cool before folding.

Disconnect the power and let the device cool before cleaning or storing. Keep liquids away from electrical parts and follow the supplied manual for cleaning. Check the cable and moving parts before use.

Match the lamp to your resin or emulsion requirements. Do not assume ordinary two-part epoxy is UV-curable. Avoid direct eye and skin exposure to UV light, and use the protection and ventilation required by your materials.

Setup and care overview. Need the complete instructions? Send us your model and order details.

1. Connect the supplied adapter and set the lamp on a dry, level work surface.
2. Arrange the two lamp sections as shown in the supplied instructions.
3. Place a compatible clear mold or small UV resin piece within the illuminated area and select the timer.
4. Check the full piece after the cycle. Pigment, thickness, and opaque molds can limit light penetration.

Disconnect the power and let the device cool before cleaning or storing. Keep liquids away from electrical parts and follow the supplied manual for cleaning. Check the cable and moving parts before use.

Match the lamp to your resin or emulsion requirements. Do not assume ordinary two-part epoxy is UV-curable. Avoid direct eye and skin exposure to UV light, and use the protection and ventilation required by your materials.

1. Assemble and secure the stand following the included instructions.
2. Position the panel over a stable surface and tighten the adjustment points.
3. Check your resin or emulsion manufacturer's wavelength requirements and make an exposure test.
4. Keep the distance and exposure conditions consistent between tests. Switch off before repositioning.

Disconnect the power and let the device cool before cleaning or storing. Keep liquids away from electrical parts and follow the supplied manual for cleaning. Check the cable and moving parts before use.

Match the lamp to your resin or emulsion requirements. Do not assume ordinary two-part epoxy is UV-curable. Avoid direct eye and skin exposure to UV light, and use the protection and ventilation required by your materials.

1. Set up the tripod with all legs stable and attach the light exactly as instructed.
2. Secure the hanging assembly and route the cable away from the work area.
3. Position a compatible project beneath the panel and establish distance and time with a small test.
4. Switch off before adjusting the assembly. Let the lamp cool before moving or storing it.

Disconnect the power and let the device cool before cleaning or storing. Keep liquids away from electrical parts and follow the supplied manual for cleaning. Check the cable and moving parts before use.

Match the lamp to your resin or emulsion requirements. Do not assume ordinary two-part epoxy is UV-curable. Avoid direct eye and skin exposure to UV light, and use the protection and ventilation required by your materials.